Member record · ID 40549
Ladajo
10 posts recovered 0 threads started First seen 3 Jul 2019 Last seen 7 Jul 2019
Recent posts
All 10- Motorcycle won’t start – fuel pump not getting enough voltage. 10 hours ago, Grum Hi Ladajo. The R/R Black wire is some form of Monitor or a Sense wire, it's job could be to sense the voltage at the supply end point, then feed that info back to the R/R so as to drive the output to…
- Motorcycle won’t start – fuel pump not getting enough voltage. I just ordered a Rick's MOSFET Regulator Rectifier. Found it on Ebay at RaceTechElectric for $100. Should be here in a few days. More thumb rolling while I wait for it. The previous one was an ElectroSport ESR438. Put…
- Motorcycle won’t start – fuel pump not getting enough voltage. Ok, I got the replacement ECM ECU. I compared pin readings, and B12 was not shorted. All else checked out. Of note was that B1& B2 are hard connected I eternally, as are B14, 15, & 16. After not finding any obvious…
- Motorcycle won’t start – fuel pump not getting enough voltage. Grum, 7/4/2019 at 1:32 PM Good job Ladajo. Rechecked my comment regards B16, it either Sensor Ground or Signal Ground, not power to the sensors. A correction for you. According to my info! B4 White/Yellow is O2 Sensor…
- Motorcycle won’t start – fuel pump not getting enough voltage. I have rung out the pins to bike check B4 & B15. Grum your information is correct and I have updated the spreadsheet to reflect this. I also verified B17 & B22 as correct. Attached is the updated sheet. Thanks for the…
- Motorcycle won’t start – fuel pump not getting enough voltage. 1 hour ago, Grum Good job Ladajo. Rechecked my comment regards B16, it either Sensor Ground or Signal Ground, not power to the sensors. A correction for you. According to my info! B4 White/Yellow is O2 Sensor 3-4 HTCL.…
- Motorcycle won’t start – fuel pump not getting enough voltage. Grum, 7/3/2019 at 7:37 PM Hi Ladajo. Are you going by the basic drawing I posted at the top of this thread? It's is somewhat generic and may NOT be entirely the same as your bike. Do you have a proper drawing for your…
- Motorcycle won’t start – fuel pump not getting enough voltage. I did buy it new and have had it since. So no possibilities of previous owner drama.
- Motorcycle won’t start – fuel pump not getting enough voltage. I found discrepancies between many docs. Including inside the service manual. The trade show pinout shows B16 as VSS, and the 2001 schematics show the VSS feed going g to the B plug. That said, tomorrow I am going to…
- Motorcycle won’t start – fuel pump not getting enough voltage. Side question for Grum. I have an 02 as well, and blew the Main B fuse. Trouble shooting showed a hard ground on the B12 Bl/W circuit. I isolated this to the ECM. No grounds showing with B plug (Grey) unhooked. I…
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.