Member record · ID 48474
Awol1379
8 posts recovered 1 thread started First seen 8 Mar 2023 Last seen 18 Mar 2023
Threads started
1 in the archiveRecent posts
All 8- 5th Gen Center Stand Install Sorry haven’t had time to post on here. I took more pictures of the center stand and ordered OEM sprockets. Looking at the center stand further, I think the stand my be bent, but I don’t see any signs of where it would…
- 5th Gen Center Stand Install I did spray paint the center stand black due to it having minor surface rust, since it was used, but I did not see any signs of damage. I’m going to look further into it tonight and double check the stand and check the…
- 5th Gen Center Stand Install 1 hour ago, bmart Any chance that the previous owner put a spacer between the hub and wheel? I don’t believe there is any spacer. I had the hub apart last year and didn’t notice any spacer. I might have to check again…
- 5th Gen Center Stand Install I checked and there are no rash or dents on the stand. The mount I no bracket shows no signs of being bent either. I tried to take photos of the offset the best I could. The wheel is the stock from my understanding and…
- 5th Gen Center Stand Install 56 minutes ago, Dash Awol - on the right foot of your center stand, is the outside edge a bit rough? I don’t believe it is, why? I’ll have to check for sure tonight but I’m more than positive it isn’t rough and looks…
- 5th Gen Center Stand Install I have the rear tire lifted and I loosened the bearing carrier. I ended up taking the chain off and planning on replacing it while I’m this deep into it. I moved the bearing carrier and it measured 21 1/2 and the center…
- 5th Gen Center Stand Install I checked and the front sprocket is 16 tooth and the rear has 43 teeth. The chain, if I counted right, is 106 links. The center stand is not bent and has the same measurements. I decided to add a center stand since it…
- 5th Gen Center Stand Install Hello everyone, just joined the website after years of owning my 2001 VFR800. I got a center stand off eBay from a parts bike and I’m trying to get it installed. I looked at the diagrams online and have the parts lined…
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.