Member record · ID 15613
Jordan
15 posts recovered 2 threads started First seen 26 Sep 2008 Last seen 7 Feb 2017
Threads started
2 in the archiveRecent posts
All 15- Stolen from Torrance (Near Los Angeles) 2002 VFR800 My beloved 2002 VFR800 was stolen yesterday from Torrance. Thief took it from below my apartment while I was hiking. It wasn't locked up :( but it was behind a gate. Keep an eye out for it if your in the region. Red…
- Stebel install question kaldek, on 13 August 2012 - 05:09 AM, said: Jordan, on 13 August 2012 - 12:52 AM, said: I mounted it behind the left fairing, near te front. I used a very thin metal bracket to hold it into place...held by the mounting…
- Stebel install question I mounted it behind the left fairing, near te front. I used a very thin metal bracket to hold it into place...held by the mounting screw near the front left of the tank. I'll post pictures when it's all finished.
- Stebel install question Go figure. It was a bad relay. All that headache for a 8 dollar relay.
- Stebel install question I'm beginning to wonder if the problem stems from the factory recall I had done in 2010. Before the factory fix, I could run accessories like heated grips and a phone charger. After the fix, the bike ran fine, but none…
- Stebel install question I'm getting power at the 87 relay diode...but not at the end of the wire, where it would connect to the horn. What gives?
- Stebel install question I'm not getting any power from the output 87 from the relay:/ time to start tracing the wires back
- Stebel install question I hot wired it, and the horn belched. However when I follow the wiring diagram, all I get is a click in the relay when I push the horn button.
- Stebel install question so why is it not working????
- Stebel install question Thanks!
- Stebel install question I bought a stebel a few years ago, but I never got around to installing it. Now that I'm finally getting around to doing some long needed installations. As far as the wiring goes...I feel like I've got way too many…
- What's The Going Rate For Some Catless Headers And Remus Ti Cans? [image: View Post]turtlecreek, on Sep 14 2009, 10:45 AM, said: kk shipped me a treat and it took a couple of days at most. my package to him was about the same....no problems here! What would happen if a 98-99 used the…
- Make It Growl For $20 I'll try to get a sound of my exhaust up tonight
- Make It Growl For $20 A member from VFRworld helped me do this mod to my bike. Instead of drilling, we cut off the end of the pipe with a angle grinder, then pulled out the baffles with a bit of tugging. Then we welded it back up and wallah!…
- Make It Growl For $20 Can anyone repost the links to the pictures on where to drill? they have expired. Is it as simply as sticking the bit through the end of the exhaust and drilling through the part of the pipe that the bit hits?
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.