Member record · ID 24163
malecure
4 posts recovered 1 thread started First seen 31 May 2015 Last seen 21 Jun 2015
Threads started
1 in the archiveRecent posts
All 4- 6Th Generation Starting Issue Turned out to be a melted connector under the seat on the 30A fuse (see image attached). Found it by jumpering power to the fuel pump and it working, then continuing upstream until the pump wouldn't prime. After…
- 6Th Generation Starting Issue haha, looks like the schematic from the haynes manual. what will holding the start switch down change? hoping not to fry the starter since the fuel pump should prime before the switch is pressed. (doesn't do this…
- 6Th Generation Starting Issue -Battery is pretty new, but still had it check out today. came back that it's in good condition and has a full charge -fuses are all functioning correctly -battery terminals are all clean and tight -bank sensor, engine…
- 6Th Generation Starting Issue 2007 Honda VFR 800 The bike quit a few times randomly while riding it. By the time I got to the side of the road it would start right back up One day when I rode to work: · No issues on the way in (20 minutes) · Bike…
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.