Member record · ID 41155
REDWING
4 posts recovered 0 threads started First seen 14 Jan 2022 Last seen 29 Jan 2022
Recent posts
All 4- What did you do to your VFR Today? I had a full givi tubular setup on by Blackbird, water got into the tubes and it rusted from the inside out. Welded and powder coated 6mm steel is far superior in my opinion.
- What did you do to your VFR Today? REDWING, 1/14/2022 at 11:32 AM Stripped my 2014 Gen 8 Bare and removed cam covers to check valve clearances. No service history when I purchased 2 years ago come Feb 1st. Made up some vtec slide pin stoppers from a 6mm…
- What did you do to your VFR Today? Done front and rear bank measurements now. All 8 VTEC clearances are tight and out of spec and 6 of 8 standard valves are out of spec, it an absolute prick of a job, fiddly, time consuming and now I think, expensive!!!…
- What did you do to your VFR Today? Stripped my 2014 Gen 8 Bare and removed cam covers to check valve clearances. No service history when I purchased 2 years ago come Feb 1st. Made up some vtec slide pin stoppers from a 6mm drill bit. Only done the rear…
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.