Member record · ID 42430
bog
7 posts recovered 2 threads started First seen 5 Sep 2020 Last seen 14 Feb 2021
Threads started
2 in the archiveRecent posts
All 7- ecu connections ok, thanks guys. There are two small release clips on the bottom of both connectors, also there is a larger clip at the top of both connectors, about 1 inch in width. I have been spending the winter performing…
- ecu connections Has anybody disconnected the electrical connections at the ecu, i was going to disconnect them for inspection and cleaning, but im not sure at what point they disconnect, some very careful prying and pulling hasnt…
- 5th gen starter valves sync INCORRECT for last 22 years Just curious, are these settings relevant to a 6th generation, i synched my 2003 the other day and set all 4 cylinders the same, but i still have what i call a stutter just off idle, the motor acts lean at low rpm to…
- carb balancing tool I havent received my service manual yet so i have a few questions, when syncing the starter valves, do you prop the tank up at the front? I have ordered a carbtune pro 4, should have it in a week. I used to sync carbs…
- carb balancing tool Squirrelman, are you using feeler guages to sync the carbs, i wondered if that method would work. bog
- carb balancing tool ok, thanks guys, ill start looking for one..bog
- carb balancing tool Ok fellas, what are some of the carb balancing tools you would recommend, there are many out there, have looked at amazon and there are many available, any recommendations? bog
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.