Member record · ID 42622
heiwaz
7 posts recovered 2 threads started First seen 23 May 2021 Last seen 2 Jun 2021
Threads started
2 in the archiveRecent posts
All 7- Different needle washer in same 4th carbs Hello, I bought a complete carbs bodies for my RC36 II and discover the needle washer in diaphragm is thicker than installed in my carbs. Why?
- How to remove carb diaphragm from 4rd gen? 7 hours ago, DannoXYZ Don't stretch too much. Just enough so length of slit = diameter of slide's groove. If I don't stretch too much is impossible to insert in gap because I need to get thinner stretching them.
- How to remove carb diaphragm from 4rd gen? 2 hours ago, Thumbs Theres NRP who sell them fitted or loose https://nrp-carbs.co.uk/ They don't sell. In price appear to call them for 4th gen
- How to remove carb diaphragm from 4rd gen? 12 hours ago, DannoXYZ Yes heat with hot water for 30-sec. Trick to getting on is same in reverse. Grab opposite sides of diaphragm and pull apart. Note that hole becomes slit which is wider than diameter of slide.…
- How to remove carb diaphragm from 4rd gen? I think understand more less your explain, but I'm not sure I can be insert diaphragm completely in the gap and once inserted can be rotate well to adjust at correct position. Maybe a video or photo will help me a lot.…
- How to remove carb diaphragm from 4rd gen? 2 hours ago, DannoXYZ heat up slides in cup of super-hot water (90-C) for 30-seconds. Grab diaphragm with 2 hands on opposite sides. Pull diaphragm apart in opposite directions. Keep on pulling until you see gap develop…
- How to remove carb diaphragm from 4rd gen? Hello I need to replace the carbs diaphragm of my RC36 4th gen, to install new ones I bought, but I can't remove the old ones. Can you tell me how to do it? [image: 16217921658092486567456272113841.jpg]
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.