Member record · ID 43874
zanshen
17 posts recovered 2 threads started First seen 12 Jul 2021 Last seen 2 Dec 2021
Threads started
2 in the archiveRecent posts
All 17- Honda's New ST - NT1100 As looks concerned it’s got same character as a tin of emulsion paint.
- ECU/WIRING LOOM 5th generation 1 hour ago, JZH The problem is probably more than the rounded bolt head. It probably got rounded because someone was trying to tighten it around an increasingly slipping mirror shaft. FYI, you can directly swap the…
- ECU/WIRING LOOM 5th generation 17 hours ago, Grum Good news you have it sorted. Having the loom replaced to fix your issue pretty well confirms what Terry suggested about the earth block, a junction point of 12 ground seeking wires built into the…
- ECU/WIRING LOOM 5th generation 4 hours ago, DannoXYZ any corner hardware store should have them. Also bicycle shoppe Can also order them from here:…
- ECU/WIRING LOOM 5th generation Hi all hope you’re well . Got bike back and all is running well. They replaced the wiring loom and that seems to have been the problem. On another note does anyone know where I can source this Allen bolt for my 1998…
- ECU/WIRING LOOM 5th generation 10 minutes ago, Grum Most unusual for the problem you have that the whole wiring harness should need replacing! However, as its a warranty issue, who cares? As long as they fix it for you. I suspect that any of the…
- ECU/WIRING LOOM 5th generation Yes mate, I popped in to the dealer yesterday and they have new wire loom ready to install. I asked them did they try any the solutions that was advised on here and they confirmed they did 😏. So they if that doesn’t…
- Random photo thread - anything goes - post what you've got My other bike .
- ECU/WIRING LOOM 5th generation Hi thanks for your help. The mechanic is Honda trained but it’s not a Honda dealership. They have checked the electrics as I have been told that is why they have ordered the ECM and loom. Its no cost to me ,if they…
- ECU/WIRING LOOM 5th generation Hi all thanks for your reply and help . The bike is still with dealer and they are ordering a new wire loom . As their mechanic ie Honda training still cannot find the source off fault. I may have to pass on your…
- ECU/WIRING LOOM 5th generation Hi all. My Vfr 1998 model is playing up. The power was dropping when head lights were on and the FI was flashing. Luckily I had a 3mth warranty on the bike so returned to dealership. They ordered a new ECU unit and they…
- New member 2 hours ago, Grum You could compare it to the other side. Guessing the black needs to tuck in between the two tangs of the silver section, locating the silver and black closer together. Remove some of the silver fairing…
- New member Can someone explain is there a clip that fastens this as it just appeared. Ie fairing slightly separated. Thanks.
- New member Dutchy, 7/13/2021 at 6:28 PM Sun in Scotland? That cannae be...... FAKE PICTURE!!! :laugh: Welcome to VFRD from across the North Sea! It’s rare mate lol
- New member Cheers
- New member Hi all thanks. Heres my 5th generation VFR
- New member Hi all I’m a new member to this club. I ride a 1998;5th generation model and a BMW R1100GS . I traded my blackbird in for the VFR and thoroughly enjoying the bike. It has 38000 and comes standard apart from screen,came…
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.