Member record · ID 18157
spinrb8r
13 posts recovered 0 threads started First seen 23 Jan 2010 Last seen 15 Sep 2014
Recent posts
All 13- 6th Gen - Blue Connector Ground Fix - How To. my vtec comes in at 5800 the power commander is disconnected and made it worse. breaks up at 6400 without the pcIII plugged in
- 6th Gen - Blue Connector Ground Fix - How To. shoulda mentioned I swapped the plugs after it failed in the 4th session. do the coil packs fail inherently or is that not likely? heat seems to make a difference too.
- 6th Gen - Blue Connector Ground Fix - How To. to add; I just went out and held 5k and blipped to 9k 4x beautiful harmonious tune no break up of any kind but also not under any load the 30amp fuse and holder are in factory condition. no discoloration
- 6th Gen - Blue Connector Ground Fix - How To. 13.24 volts at the battery off 14.48 volts at idle 14.49 volts at 5000 rpm good or bad ?
- 6th Gen - Blue Connector Ground Fix - How To. Thanx Switch. Somewhere to start. I'll report back on findings
- 6th Gen - Blue Connector Ground Fix - How To. Not sure if this is where my problem lies cuz the symptoms are different and my bike's an '06 but here goes.... Was at NJMP for the AMA teaching/track event this weekend and couldn't complete it cuz after 3 sessions I…
- VTEC-SC... Well Gentlemen, As you've seen throughout the thread Dan is a genius, and a very personable guy. I've been working alot of long hours so I haven't been on the bike as much as I'd like but the SC is AMAZING! Fit and…
- VTEC-SC... [image: View Post]tx_vfr, on 20 May 2010 - 11:29 AM, said: While you're in there, you should put in a Stebel horn. The trick being they're much larger then the stocker. Mine is mounted to the original mounting location…
- VTEC-SC... [image: View Post]tx_vfr, on 20 May 2010 - 11:29 AM, said: While you're in there, you should put in a Stebel horn. The trick being they're much larger then the stocker. Mine is mounted to the original mounting location…
- My New VFR1200F USA Absolutely stunning.........can't wait to tangle with one someday.
- VTEC-SC... [image: View Post]kaldek, on 10 March 2010 - 07:28 PM, said: Also, that gap in the air vent looks a little ugly. I suggest it needs a nice little laser-cut bracket which says "Rotrex Supercharged". :biggrin: suffice it…
- VTEC-SC... OK gang here goes; The donor bike belongs to me, Spinrb8r. To the post that wants to see the cat-off true 2 1/8" stainless duals with Ferrachi Forza Carbon Cans I posted them after the fabrication was finished several…
- Anyone tried one of these "Mini" cans? I like 'em, but then I liked my Carbon Forza's so much I had my buddy fabricate them 5" shorter for my '06 undertail[image: 015.JPG]
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.