Member record · ID 19246
Junyr
10 posts recovered 1 thread started First seen 4 Feb 2010 Last seen 16 Jun 2011
Threads started
1 in the archiveRecent posts
All 10- Newbie here. I'm a bit stumped on this one. Ideas? What temps are you running at normally? If it's below 168 you'll be running rich and likely have a bad thermostat. WhenI got my 2002 I was getting 23 mpg. I replaced my thermostat at the mpg went up to 29, then I…
- 6th Gen Running Cold. Unknown Cause [image: View Post]tx_vfr, on 03 December 2010 - 11:46 AM, said: I dug through the FSM and there is only one Engine Coolant Temp sensor. I'm beginning to wonder if I should fault the MAP or IAT sensors. Any luck with…
- 6th Gen Running Cold. Unknown Cause [image: View Post]tx_vfr, on 27 January 2010 - 05:18 PM, said: I've gone over the routes for the hoses multiple times and I'm 99% sure that the hoses are correctly connected. Most of the hoses simply can't be crossed…
- The Official Oil Thread I use the Rotella Synthetic now that it's got the proper JASO rating... With that being said, I'm one of the mindset that what you use isn't near as important as changing it at the appropriate interval.
- Vtec Shock Options [image: View Post]BaileyRock, on 07 February 2010 - 02:57 PM, said: [image: View Post]Junyr, on 06 February 2010 - 08:00 PM, said: [image: View Post]BaileyRock, on 05 February 2010 - 06:12 PM, said: [image: View…
- Vtec Shock Options [image: View Post]BaileyRock, on 05 February 2010 - 06:12 PM, said: [image: View Post]Junyr, on 05 February 2010 - 04:51 PM, said: I'm not a real aggressive rider, but I would like my suspension to be more tuned to my…
- Upper fairing support ben? (pics) [image: View Post]BaileyRock, on 04 February 2010 - 02:56 PM, said: When you low side a VFR it tends to just Rotate the upper stay away from the drop side, many times a simple twist of the main cross bar with a pri bar…
- Upper fairing support ben? (pics) It not terrible. The PO told me last spring he just took a corner a little too far before the tires got warm and it slid out from under him. Everything is straight as far as the important things go that make it ridable.…
- Upper fairing support ben? (pics) [image: View Post]steven113, on 04 February 2010 - 11:55 AM, said: Not to say that it is impossible to straighten one out but it is very difficult to get it right. IMO it is a part that is worth buying new from honda to…
- Upper fairing support ben? (pics) How's it going? I'm pretty new here with just recently getting my '02 and had a question about some damage. The bike was lowsided by the previous owner and I'm looking at repairing some of the damage. I've attached some…
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.