Member record · ID 25187
FlyingDeck
6 posts recovered 0 threads started First seen 3 Sep 2014 Last seen 8 Oct 2014
Recent posts
All 6- More Complex Than What I Am Used To...'86 Vf500F YoshiHNS Yep. Just a flathead screwdriver and a 7mm wrench IIRC. There's a trick where you turn the engine over a bit to put some pressure on the tappets, and then tighten down the nut. Keeps the tappet in place better…
- Change A Rear Tire Without Center Stand Not had to do it but I would say first loosen off the wheel nuts and do whatever is necessary to the exhaust (and brake calliper if it is a 1st or 2nd gen). Last thing you want to do is start heaving on wheel nuts with…
- Rc36 750 Carb Issue? (Vid Inside) [image: a6ydu9en.jpg] The diaphragm is in the pic on the left. The cylinder with a rubber diaphragm at one end and a needle at the other. Th access remove the four screws on the cover (top right in picture) If indeed…
- Rc36 750 Carb Issue? (Vid Inside) Try gently pushing the slide with a screw driver to see if it is stuck. Also of you remove the air box and plenum (the plate between the carbs and air box! You can remove the carb top and then remove the slider. If…
- Refurbishing A Stolen, River-Found, Vfr 750... And checking the clutch switch...
- Bagster Tank Bags I bought two second hand 14 years ago. The large one has almost never been used. The small one has almost never been off the bike. It's like having a glove box. [image: sa9ypuvy.jpg]
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.