Member record · ID 2523
spawningvat
6 posts recovered 1 thread started First seen 5 Jan 2011 Last seen 15 Mar 2013
Threads started
1 in the archiveRecent posts
All 6- Engine Swap Tips? I just swapped an engine into a 4th gen frame. This job was a bit easier because the 4th gen swing arm mounts to frame. The 5th gen swing arm mounts to the engine. Here's how I did it: -Loosen/remove as much as…
- Help with 1996 VFR 750 project Ok, so the general consensus is that the engine is gone. Damn. Looks like I'm in the market for a 4th gen engine. Anyone know anyone?
- Help with 1996 VFR 750 project I've downloaded the service manual and have studied it. It looks like i can reuse most of the bolts. Will need new gaskets, and bearings. I'm hoping to pull the engine, flip it over, rotate pistons to a midway point,…
- Help with 1996 VFR 750 project Update: Pulled the clutch side cover, and could see #3 and #4 con rod bottoms through a hole. I pried at #4, and it didn't move. I pried at #3 and it moved approximately 2mm back and forth and up and down. There's the…
- Help with 1996 VFR 750 project Hello Everyone: So I have a little project on my hands, and I'm looking for some help and advice. I just got a 96 750 with about 23000 miles on it. It had been in an accident, so its missing the entire fairing and…
- So what cool stuff did you get for X-mass Got this: and a few of these: Old headers and collector have been getting progressively worse up to 58k miles. Been riding loudly for the past year and a half. It was bad enough that when started in December, I got…
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.