Member record · ID 38619
Snapper
4 posts recovered 1 thread started First seen 18 Jul 2017 Last seen 16 Apr 2018
Threads started
1 in the archiveRecent posts
All 4- Post your Voltmeter mount pics My first attempt at fitting a voltmeter involved using this rather 'Radio Shack' looking, multi-LED device, which I mounted on the bracket for the heated grips controller :unsure: ... [image:…
- What if I remove the catalytic convertor? swas, 7/30/2017 at 9:09 AM I've been researching the same conversion and assumed the two plugs shown on the right angled mixer in the parts explosion pic were for O2 sensors? I think you're right - I didn't spot that…
- What if I remove the catalytic convertor? Please forgive my laziness and lack of research, but I have a simple question for those who understand what a 'cat' does ... If I remove the entire stock exhaust system from my 2001 (pre-VTEC) VFR800 and replace it with…
- Post your Voltmeter mount pics I was too afraid to cut holes in my lovely new (to me) VFR800, so I decided to go 'old school' and fit an LED voltmeter to the mounting bracket for my heated grips. The end result may look a bit 'Radio Shack', but I…
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.