Member record · ID 12198
racercosmo
10 posts recovered 0 threads started First seen 25 Dec 2007 Last seen 25 Jun 2009
Recent posts
All 10- R/r Wiring Fix For 1990-1997 Vfrs So some other issue is there. With a fresh charge on the battery overnight, I made it 80 miles, stopped. I checked the battery, 12.7 volts parked, then with it running it was 12.2 then revving it up went to 13ish. Once…
- R/r Wiring Fix For 1990-1997 Vfrs Everything is on the bike now, and hooked up. It is charging, but it seems like not enough. I have the voltmeter on the battery terminals, and at idle it's 12.5. I rev it up to 6k and it goes to about 13. It seems like…
- R/r Wiring Fix For 1990-1997 Vfrs VFRness is installed. The starter relay plug was burned pretty bad, I replaced it. That was the worst looking of the three. About as bad as the one pictured above. I'm still waiting on the R/R though, so I'm dead in the…
- R/r Wiring Fix For 1990-1997 Vfrs I ordered a R/R and VFRness for my 3rd gen today. Thank you.
- R/r Wiring Fix For 1990-1997 Vfrs Is this the kind of thing that any idiot can install? Instructions included? I will be calling you after payday.
- Conti Road Attacks After 8,000mi [image: View Post]Rothman, on Nov 29 2008, 12:13 PM, said: These are the tires that the Katana wears. I have only put about 5k miles on them and upon pre-ride inspection this morning, I found that the tire is cracking…
- More Rumors I was just reading about the 990 MotoGP bike. Would anybody else like a V5 VFR? That would be an easy liter. I believe it should remain the type of bike it is though. The CBR1000 is fine by itself, Honda doesn't need…
- Wheel Interchangeability: What Can I Use? [image: View Post]JZH, on Dec 26 2007, 11:07 PM, said: [image: View Post]racercosmo, on Dec 25 2007, 01:32 AM, said: So I wanted to be clear. A 4th gen wheel will fit on a 3rd gen with no problems? I have a wheel with…
- Wheel Interchangeability: What Can I Use? Sorry, the front wheel.
- Wheel Interchangeability: What Can I Use? So I wanted to be clear. A 4th gen wheel will fit on a 3rd gen with no problems? I have a wheel with bearings, rotors, axle, and spacers. What should I use? Thanks in advance.
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.