VFRDiscussion ARCHIVE / READ-ONLYREAD-ONLY

Warning Sticker Removal

20 posts Started 12 Feb 2007 Last recovered post 12 Feb 2007 Wayback Machine snapshot 11 Jan 2008

#1
I am planning to remove the warning stickers from my gas tank. What is best solvent to use to peel them off the tank that won't damage the finish?
#2
Aaron a little heat from a hairdryer then some goo gone should do the trick fing02.gif
#3
dude, Feb 12 2007, 11:43 AMAaron a little heat from a hairdryer then some goo gone should do the trick fing02.gif

What he said +1.gif
#4
Modifying your Honda product is not advised. Leave the stickers on!!









goofy.gif
#5
Goo Gone. Get the corner of the sticker up and if you are careful it will peel right off.

Believe it or not, if it is really cold out, they will peel right up too. Most adhesives fail in the presence of extreme cold and heat. (Duct tape is a great example!)

Later,
Jeff
#6
Kanadian Ken, Feb 12 2007, 03:07 PMModifying your Honda product is not advised. Leave the stickers on!!









goofy.gif

Nothing better than reading you could be hurt or killed, wear your helmet, yadayadayada....DUH....if we couldn't figure these things out, we would have never mastered clutch is on the left, front brake is............................ pissed.gif
#7
Kanadian Ken, Feb 12 2007, 02:07 PMModifying your Honda product is not advised. Leave the stickers on!!

goofy.gif


Yeah, but the bike goes faster without them.
#8
A blow dryer and a can of WD40 is all you need.
Soften the sticker with the dryer to remove it. Then squirt a little WD on the remaining glue and rub it with a T-shirt.
#9
If you don't have Goo Gone or WD40 or whatever, just use gasoline.
Or paintbrush cleaner.
Or turpentine.
Or methylated spirits.
Or kerosene.
Or cheap whisky.
Or tequila.
Or your wife's/girlfriend's/boyfriend's perfume (the one you don't like the smell of).
#10
dude, Feb 12 2007, 01:43 PMAaron a little heat from a hairdryer then some goo gone should do the trick fing02.gif

+1.gif Just make sure not to over heat or burn the sticker and/or the paint...
#11
2003_VTEC_Rider, Feb 12 2007, 02:24 PMGoo Gone. Get the corner of the sticker up and if you are careful it will peel right off.

Believe it or not, if it is really cold out, they will peel right up too. Most adhesives fail in the presence of extreme cold and heat. (Duct tape is a great example!)

Later,
Jeff

Well good for this thread cause I have some I'm going to remove!! :thumb:

For some reason I am getting a funny picture in my head 2003_VTEC_Rider of me leaving my bike outside to get it nice and cold!!! unsure.gif LOL!! (Not that it would still BE there in the morning I'm sure ...)
#12
The sticker/tag police have been notified.

They shall be along shortly, after they bust some hump over if Okaloosa, some renegade out there pulled of his friggin' mattress tabs.

Dad gum had dat whippin' coming, he did. Pulling off stikkas an whatnot.... dry.gif *spittoon hit*
#13
That reminds me - I have some "HECC" stickers to remove.
Don't tell the Sticker/Tag Police.

Or my WifeAccountantPorcupine.
#14
enzed_viffer, Feb 12 2007, 11:40 PMThat reminds me - I have some "HECC" stickers to remove.


What the HECK is HECC?
#15
afennell, Feb 12 2007, 12:28 PMYeah, but the bike goes faster without them.

Which is inversely proportional to all those ricer cars you see on the road now-a-days. rolleyes.gif
#16
3M adhesive remover. Available at normal parts stores.
#17
skuuter, Feb 12 2007, 01:25 PM
Kanadian Ken, Feb 12 2007, 03:07 PMModifying your Honda product is not advised. Leave the stickers on!!









goofy.gif

Nothing better than reading you could be hurt or killed, wear your helmet, yadayadayada....DUH....if we couldn't figure these things out, we would have never mastered clutch is on the left, front brake is............................ pissed.gif


Is that why I never could keep up with you?? goofy.gif
#18
use a blow torch! goofy.gif

make sure gas tank is 1/2 full.. and the cap OPEN!!!

the tank will KABLAMO!!!
.. get tank fixxed... custom paint job...
strickers will be the least of your worries!!! fing02.gif
#19
Dutchy, Feb 13 2007, 11:50 AM
enzed_viffer, Feb 12 2007, 11:40 PMThat reminds me - I have some "HECC" stickers to remove.


What the HECK is HECC?

"Hippy Environmental-Consciousness Crap."

LOL.

*runs downstairs to see what it DOES mean*

Oops - it's actually HECS 3.
So that would be "Hippy Environmental-Consciousness Sh1t."

Apparently it stands for "Honda Environmental Catalyzing System (3)".
So, it's Hippy/Greenie Crapola in other words.

And as of tonight, history.
No point in modifying my bike to spew more partially burnt petroleum distillates / noise into the atmosphere if it has a sticker saying how clean and green it is, is there?
491.gif
#20
gll429, Feb 12 2007, 07:36 PMuse a blow torch! goofy.gif

make sure gas tank is 1/2 full.. and the cap OPEN!!!

the tank will KABLAMO!!!
.. get tank fixxed... custom paint job...
strickers will be the least of your worries!!! fing02.gif

goofy.gif goofy.gif goofy.gif
End of thread · 20 posts recovered Wayback Machine snapshot 11 Jan 2008