Member record · ID 18914
SJC
9 posts recovered 5 threads started First seen 27 Nov 2009 Last seen 9 Jun 2011
Threads started
5 in the archiveRecent posts
All 9- pcv + speedohealer, pcv second map. Hi Peoples, I have two questions..................... Firstly, I remember somewhere on here that you can't have a Pc-V fitted then install a speedohealer cause it play's up on the Pc-V unit. Is that right or have a got…
- Footpeg mounting kit Found this on e-mail and was wondering if anyone had tried them? Also if you have, do you have any pic's of them fitted to the bike.
- Dropping the pillion pegs Mac, on 02 September 2010 - 04:31 AM, said: Howdy, My wife would raise a the same complaint after a couple of hours. I got a new set of passenger pegs from Twisted Throttle. They helped a lot, but I was worried that I…
- Dropping the pillion pegs Hello Peoples, My partner has been hopping on the back lately but finds the pegs are to high for her and she gets pains in the top of her leg. So just wondering if anyone on here has come up with a way of dropping the…
- Just Installed Power Commander 5 On My '06! I have just brought one of these but was wondering............. I have gone down one tooth on the front sprocket, will this effect the pc v's gear ratio? Also you mentioned at the start that there was a calibration that…
- 19 mm tailriser? Thanks guys, I'll go and do some searchers on setting the sag and see how it goes. Also some people have said the lowering the forks increases the turn in but also some have said that rising the forks increases turn in.…
- 19 mm tailriser? One of the mod's that I have been advised to do is put a 19mm tailriser on for better turn in. But my question is, is this the one I need as I have been shown a picture of one but it didn't look anything like this one.…
- Delkevic headers So I don't have to add headers but it's a good idea if I can afford it. How much better will the bike go with these headers and also are these any good or should I look for some motard's? Ok guys, here's some pic's…
- Delkevic headers Hello peoples, I'm looking at putting a new set of pipes on my 09 vfr800 and have been told that I'm also best to change the headers at the same time. Now I've been told to use a set of motard's or headers off of a…
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.