Member record · ID 38568
PetePower
39 posts recovered 1 thread started First seen 13 Jul 2017 Last seen 4 Feb 2021
Threads started
1 in the archiveRecent posts
All 39- What did you do to your VFR Today? Replaced the Air Filter 20000kms
- Leftover 2014 VFR 800 with 1km I scored a new 2014 in 2017, actually 3 years ago on 15/7/20. Did oi,l coolant, brake, clutch, new battery. Tyres weren't bad and were punctured early on. Hope you get a great deal.
- What did you do to your VFR Today? I did the Front Fork oil replacement on my 2014, went well though a little bit of mucking around getting the damping rod adjuster right on the first one, learnt the lesson for the 2nd one. I have also been busy with…
- SC Project - VFR800F Love it, now I know what mine sounds like to others. I gather that's with the DB killer removed?
- Arrow Exhaust installation KYVFR800, 6/16/2019 at 2:14 AM Got out for about a 40 minute ride yesterday, pipe sounds good, nice little rumble without being too loud for the rest of society (IMO). I let it cool down and have fired it back up…
- The dreaded valve adjustment 17 hours ago, Mohawk As any scientist will tell you a sample of one has NO statistical worth as there is no data to compare it with. Agree completely, and as I stated I checked the valve clearances twice on my Yammy.…
- Arrow Exhaust installation Classy pipe those Arrows, nearly as nice as my SC projects 😉 Yeah gasket wouldn't fit with mine either.
- Slipping Clutch Thank you for your responses. Not 100% but I think I may have over filled the reservoir!! I re-bled two lever pulls, no bubbles. Gave the lever a few more pulls and actually pulled out the little plate in the bottom of…
- Slipping Clutch Yes the plan is to give it a re-bleed tonight and fingers crossed issue resolved. Just hope the plates haven't been glazed up...
- The dreaded valve adjustment If the VTEC valves are the tricky and therefore expensive part of the check could you not make a calculated decision on the results of the standard valve check. If they are within tolerance then surely the VTEC valves…
- Slipping Clutch What have I done.... The other week I flushed the Brake and Clutch fluid on my 2014 VFR, using recommended Dot4. All went well so I thought. Only rode one day last week but have ridden every day this week. Earlier in…
- What did you do to your VFR Today? Replaced the rear tyre as spiked by a nail, was original Dunlop 222 with 11000kms so just about done anyway, just didn't get to do the throw away burnout... Have gone with a Roadsmart III
- Gear selector indicator... Yep not on your own, poor shift :sad:
- Kriega US 30 I went with a Nelson Rigg Tail bag I think its expandable to 30ltr, a little bit of mucking around to work out best securing but happy so far. Got one for the wifes bike as well. [image:…
- side stand lean angle? Always turn the wheel to full lock up hill when parked :sad:
- Handlebar Risers I added the 15mm Honda risers to my 2014, no change at all to handling, and really no noticeable change to position but a little more comfortable.
- Just my luck. T-Rex no cut frame slider FAIL I have had the bike fall over twice, once rolled off the stand and 2nd time I put my foot down in oil both times the R&G sliders saved the fairings.
- Pardon The Nudity... Fantastic job, great result.
- Exhaust Gday fellow Croweater Xplora. Would you happen to be the rider of the VFR I often see parked out front of the Maid of Auckland?
- 2017 VFR Exhaust Love my SC Project on my 14'
- Picture Thread Happy VFR Day 1yr old today :fing02: , pity it was wet on the way to work. Birthday bath tonight :smile: [image: 2102314330_VFR1yr.thumb.jpg.98b420140c80bd2dbc33182c01f2b392.jpg]
- Hello from Nebraska Love the exhaust. Don't know anything about the ECU flashing?? With the ECU Flash did you tell them the exhaust setup you were doing? I wonder if the lil shorty exhaust will make it a bit Lean?
- What did you do to your VFR Today? lazyeye, 6/29/2018 at 2:57 PM Bled the front brakes for the fourth time then went out to test them. Seemed better than the last time. Maybe its my imagination but it seemed like the lever got a bit softer after I…
- New VFR1200 Owner Here Looks great, and a nice backyard. Good luck with the racing.
- 2017 VFR Exhaust Looks great, sounds nice.
- Cooling Fan Operation Test Tried it and it didn't work
- Exhaust SC Projects, sounds awesome, looks pretty good :cool: Titanium with Carbon fibre cap [image: SC_Side.thumb.jpg.89237c5c3f646f3f5ec2feb430cb9322.jpg] [image: SC close.jpg]
- May sell my '14 Keep and get a boat Problem solved
- Cooling Fan Operation Test I will give that a try when I leave work.
- What did you do to your VFR Today? 1 hour ago, BlueTraveler I [image: xO4Bed.jpg] What brand and size is your Tail bag looks very neat and the perfect size. I notice you must also have a Tank bag as it looks like a fuel cap locking ring is fitted? So…
- Honda VFR800 2017 Spare Key ? cost after market mybikemylife, 30/07/2017 at 6:21 PM most probably someone may have done this already so seeking advise on where and how to get a spare key cheaper in Australia ? Dealer cost is approx $240 and am thinking if can…
- What did you do to your VFR Today? jhenley17, 13/01/2018 at 3:30 AM Does it make a little bit of noise or is it quiet as an Akra or Arrow? Sent from my iPhone using Tapatalk I haven't heard the Arrow or Apra on a VFR. I did last week with the DB…
- What did you do to your VFR Today? I fitted my new SC Projects Titanium Conic Carbon Cap exhaust. [image: 5a581be1dd604_SCSide.thumb.jpg.70f2ab5994c82f258b119e1b3a827a33.jpg][image: 5a581c03787f1_SCclose.thumb.jpg.e42ad06069fe79e5d57a72647138c3df.jpg]
- Picture Thread Mint, 9/12/2017 at 12:16 AM and has built in garage opener. :) Like to learn how you did the Garage door opener, sounds like just what I need. Here a shot of His(mine) and Hers with the Jacarandas in bloom on our…
- Picture Thread adprom, 15/10/2017 at 10:05 PM And some more... had to go to canberra for work... and back... About 740km each way via the princes highway and monary highway (there is a quicker way via the Hume that is 670km - but…
- New Hepco Becker C-Bow Saddlebags A lot more affordable than the Honda hard boxes. Doesn't look like too hard to fit and remove. Which is a big bonus with the Honda boxes.
- Any New Frame Sliders? 5 hours ago, fatshoutybloke Yes, I bloody have. On the way home from work today, on a pile of gravel at a junction with a country lane. They did their job, no damage to the lower or middle fairings at all. [image:…
- 2017 VFR800F worth paying AUD $14,800 ? ( Australia) mybikemylife, 11/07/2017 at 11:57 AM thanks everyone so far for the input, able to get quote of $14400 ( can pay via credit card ( no fees) as well) I have just picked up A brand new 2014 plated for very good price…
- Any New Frame Sliders? fatshoutybloke, 11/06/2017 at 1:23 AM I got them on eBay from T-Rex themselves but looking on their site the VTEC version is this... http://t-rex-racing.com/catalog.php?item=878 Cost me more with import taxes and…
Member profiles were not captured; this page is assembled from the posts that were. Post counts reflect what the archive recovered, not the forum's own totals.